Tools photo page...

Note: Only tool products still on hand are available. When currect stocks are gone I do not know if I will make any of these in the future....12/2006.

#T-1 tool. top view and bottom view... notice second set of bolts for early model fan bearing support hub. Re-lubricates bearing in place on engine with grease gun. (with instructions)

#T-2 Fan Idler Bearing Tool, for re-lubricating the fan idler pulley with your grease gun, either on or off engine.

#T-4 Push Rod Tube Removal Tool (Use when exhaust manifolds are removed first)

#T-5 Transaxle Side Sleeve adjusting tool (protects cast iron ears).

#T-6 Transaxle Front Bearing Sleeve adjusting tool. (shown being used)

#T-9 Plexiglass covers to "CC" combustion head chambers. Set of three with air bleed ports.

#T-10 Oil Screen Installation / Removal tool (Clamps on tube so screen can be driven into or out of aluminum engine block.

Shows tool in use...

#T-11 Oil Pump Priming tool. Mount in electric drill and prime engine oil pressure before starting dry engine. (Has bottom bearing).